Wireshark Superusers,
I am using the new beta version of wireshark "Version 1.4.0rc2 (SVN Rev 33665 from /trunk-1.4)" on a windows XP laptop with Service Pack 3.
I like and have used the feature to manually resolve the IP addresses to a name that I determine instead of showing the IP address. Unforutunately, if I use this feature, it does not allow me to change the resolved IP name back to an IP. I have to close the Wireshark application to get back to seeing IPs again.
Is there a way to change the resolved IP addresses back to unresolved IP addresses without having to shut down the Wireshark application? Also, is there a trick to just manually resolving a single IP address rather than the entire file?
Thanks,
George
PS. The way that I am resolving the IPs to a host name is as follows
Have the cursor on the IP address that I wish to resolve.
right click and select "manually Resolve Adress"
type in the name that I wish the IP to resolve to
check the "enable network name resolution"
and click OK
