Wireshark-users: Re: [Wireshark-users] Error when only selective protocols are enabled
This was fixed a while ago, it has been already delivered in either
0.99.8 or 0.99.9.
http://anonsvn.wireshark.org/viewvc/viewvc.cgi?view=rev&revision=24109
On 31-Mar-2008 14:45:06 ZE5B, Tapas Chatterjee
<tapas.chatterjee@xxxxxxxxxxx> wrote:
>
>
> Hi ,
> I am using wireshark 0.99.7. I have disabled all the protocols through the
> Analyze->Enabled Protocols menu,
> And only enabled a few protocols that I am monitoring e.g, Ethernet, IP,
> UDP, RTP.
> But there is a problem in the detailed dissection pane.
> After dissecting the packet subtree correctly, one additional subtree is
> shown at the end called "Data". This "Data" highlights the whole packet
> bytes again.
>
> This problem is not there when all the protocols are enabled (default).
> Is there any configuration that I am missing ?
>
> Please tell me how to overcome this.
>
> with regards,
> Tapas Chatterjee
>
>
>
> *********************** Aricent-Unclassified ***********************
>
> "DISCLAIMER: This message is proprietary to Aricent and is intended solely
> for the use of
> the individual to whom it is addressed. It may contain privileged or
> confidential information and should not be
> circulated or used for any purpose other than for what it is intended. If
> you have received this message in error,
> please notify the originator immediately. If you are not the intended
> recipient, you are notified that you are strictly
> prohibited from using, copying, altering, or disclosing the contents of
> this message. Aricent accepts no responsibility for
> loss or damage arising from the use of the information transmitted by this
> email including damage from virus."
>
> _______________________________________________
> Wireshark-users mailing list
> Wireshark-users@xxxxxxxxxxxxx
> http://www.wireshark.org/mailman/listinfo/wireshark-users
>
>
--
This information is top security. When you have read it, destroy yourself.
-- Marshall McLuhan
