Wireshark-users: [Wireshark-users] Error when only selective protocols are enabled
Hi ,
I am using wireshark 0.99.7. I have disabled all the protocols through the Analyze->Enabled Protocols menu,
And only enabled a few protocols that I am monitoring e.g, Ethernet, IP, UDP, RTP.
But there is a problem in the detailed dissection pane.
After dissecting the packet subtree correctly, one additional subtree is shown at the end called "Data". This "Data" highlights the whole packet bytes again.
This problem is not there when all the protocols are enabled (default).
Is there any configuration that I am missing ?
Please tell me how to overcome this.
with regards,
Tapas Chatterjee
*********************** Aricent-Unclassified ***********************
"DISCLAIMER: This message is proprietary to Aricent and is intended solely for the use of
the individual to whom it is addressed. It may contain privileged or confidential information and should not be
circulated or used for any purpose other than for what it is intended. If you have received this message in error,
please notify the originator immediately. If you are not the intended recipient, you are notified that you are strictly
prohibited from using, copying, altering, or disclosing the contents of this message. Aricent accepts no responsibility for
loss or damage arising from the use of the information transmitted by this email including damage from virus."
