Wireshark-users: [Wireshark-users] how to enable ip reassembly in tshark
Date Index · Thread Index · Other Months · All Mailing Lists
Date Prev · Date Next · Thread Prev · Thread Next
From: "Wenling Li -X (wenlli - CIeNET at Cisco)" <wenlli@xxxxxxxxx>
Date: Fri, 8 Dec 2017 09:06:39 +0000

Hi wireshark supporter,

 

I installed wireshark software on my Ubuntu 16.04, and when I using tshark to capture packets, I found that one of the sip packet which is more than 1500bytes is fragmented as two ip packets.

 

But if I using wireshark to capture all the sip packets can be shown completely, the bigger sip packet which is more than 1500 bytes can be displayed in one packet in wireshark.

 

My tshark and wireshark version is 2.2.6.

 

So I’m confused, then I checked the preference of wireshark, and found that ip reassembly is enabled by default, you can reference as below screen shots:

 

         

Now I need do some automation about capture packet and analyze packets, so it’s difficult to me if the sip message is fragmented as IP packets.

Is there any solution for this problem? Expect for your response and thanks for your strong support!

 

Br

Lily