Wireshark · Wireshark-users: Re: [Wireshark-users] Incorrectly framed messages

[Martin Visser <martinvisser99@xxxxxxxxx>]

Depending on your capture setup, wireshark should be seeing all of the frames on the, regardless of whether they are valid TCP segments or not. As Bill has said, unless they are frames broken at the physical level - they should be there.

If they are shown as "malformed" TCP segments, it sounds like there is something up with your TCP stack - is this home-grown or are you just putting your app on to a standard Windows/UNIX/Linux stack?

You can tell Wireshark to turn off all decoding, for instance TCP, so at least you will see the raw frames.

You probably need to post a link to a capture to help us understand the problem.

Regards, Martin

MartinVisser99@xxxxxxxxx

On 12 March 2013 09:55, Bill Meier <wmeier@xxxxxxxxxxx> wrote:

On 3/11/2013 3:58 PM, Lobb, Janos wrote:

Hi,

We have an application that receives TCP messages - HL7 formatted -,
into a holding table and processing them later.  We found that
because of a bug/limitation in the program it is unable to put
together messages that are bigger than 32K.  I understand that the
parts above 32K is not shown in the table, but I do not understand
why do I not see them in a WS capture.

The messages contains different segments, like MSH, IN1, IN2, ROL,
etc…    There is a server that sends these messages and there is a
client that receives them.  My assumption was that even if the bug is
in the client program I still should see the above 32K part of the
message in wireshark, but I do not.

The message just breaks and the client sends back an ACK message but
with some missing IDs, that causes the server to garble up the next
message even if that is just a short one.

When I look the Expert Info Composite, I see plenty of Malformed
messages, about 15,000 from 540,000, but none of them contains the
above 32K part of the incorrectly framed messages.

Any insight ?  Does Wireshark just drops them ?  If yes, is there a
setting to force WS to show them even if they are malformed ?

Thanks ahead,

János P.S.  Now, this "incorrectly framed message" text is put into
the error table by the client program, so it is not necessarily a
good labeling of the symptom from the networking point of view.

Knowing nothing about the HL7 protocol I'll just make some general comments.

As far as I know, Wireshark does not have a specific dissector for the HL7 protocol (assuming you aren't using some custom version of Wireshark).

So: it should be the case that what Wireshark shows is what is on the wire. (Assumption: there isn't some low-level ethernet checksum issue or similar causes packets to be dropped before thay are captured; this is quite unlikely).

Wireshark itself wil show all the frames, altho as you note it may have difficulty dissecting them completely.

___________________________________________________________________________
Sent via:    Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
Archives:    http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
            mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe