I just
bought an AirPcap Nx device but I can't get reliable data for 2.4GHz 802.11n
networks.
The AP is
configured for "Up to 130Mbps", client is configured for max 65Mbps,
MCS7, 20MHz channel, 800ns GI, 1 spatial stream.
The network
is open (no WEP or WPA).
I can see
upstream frames (from client to AP) but no downstream frames, except for ACKs
and beacons.
I get a lot
of invalid frames though (incorrect FCS), where downstream data frames should be.
If I
configure the AP for 802.11g ("up to 54Mbps") and client accordingly
(54Mbps) everything looks good.
I tested it
using iperf configured for UDP @ 32Kbps, bidirectional.
Attached
capture files were collected with Wireshark, using the following versions:
Wireshark
Version 1.8.1 (SVN Rev 43946 from /trunk-1.8) x64
Airpcap
software version 4.1.1
WinPcap
4.1.1
I tried to contact riverbed on this issue with no luck.
Thanks,
Valerio
Attachment:
Airpcap_11n_issue.zip
Description: Zip archive
