Wireshark · Wireshark-users: Re: [Wireshark-users] iperf UDP throughput

["netztier@xxxxxxxxxx" <netztier@xxxxxxxxxx>]

Well, it says so:

D:\iPerf>iperf --help

[...]

Client specific:
  -b, --bandwidth #[KM]    for UDP, bandwidth to send 
at in bits/sec
                           (default 1 Mbit/sec, implies -u)
[...]

regards

Marc

-- 
netztier@bluewin.
ch


>----Ursprüngliche Nachricht----
>Von: abhishekfishy2000@xxxxxxxxx
>Datum: 27.03.2012 10:40
>An: "Community 
support list for Wireshark"<wireshark-users@xxxxxxxxxxxxx>
>Betreff: [Wireshark-users] iperf UDP throughput
>
>Hello 
All,
>
>This is not exactly a wireshark question still posting here and this list
>gives very good explanations.
>
>

>I'm using Wifi in g mode and WPA2AES between an Linux AP and Windows STA
>
>I initiated a iperf TCP client|server for 
90 sec and observed throughput
>was 11Mbits/sec
>With UDP its just 1.04Mbits/sec
>
>Wireshark shows both TCP and UDP 
packets transmitted at 54 or 36 Mb/s.
>
>I'm not able to understand why is UDP throughput so low
>
>commands
>
>iperf -
s -u   (Win 7 STA)
>iperf -c <IP> -u -t 90  ( linux AP)
>
>regards
>Abhishek