Hi Jaap,
Thanks for your reply. So when i launch wireshark from command line, there are no errors shown..
But under "About -> Plugins" box; no plugin is shown. I assume none of the plugins are loaded..
So I am wondering, is there an internal wireshark log which I could look at the figure out what's going or is there a way to loaded plugins manually one by one in the GUI?
Regards
Omer
On Mon, Feb 7, 2011 at 22:09, Jaap Keuter
<jaap.keuter@xxxxxxxxx> wrote:
Hi,
Try to launch from the command line, in the build directory, using:
./wireshark
and see what appears at the console. Also check the About box, the plugins page to see if your plugin is listed there.
Thanks,
Jaap
On 02/07/2011 05:25 PM, Omer Khalid wrote:
Hi,
I have been trying to get my plugin working with Wireshark 1.4.3 on
Fedora 14 but with out luck.
Every thing compiles fine (after configuring the following files
[configure, configure.in <http://configure.in>, makefile.am
<http://makefile.am>, makefile.common, plugins/makefile.am
<http://makefile.am>] to point to the plugin/my_plugin_folder) but I
don't see the plugin in the filters.
Just to exclude the option that I may not be doing it the correct way; i
also compiled this test plugin
(
http://www.codeproject.com/KB/IP/custom_dissector.aspx) and yet this is
not visible either...
I am wondering if I am missing any further steps after executing
autogen.sh, configure, make?
Regards,
Omer
___________________________________________________________________________
Sent via: Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
Archives: http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe
