Wireshark · Wireshark-users: Re: [Wireshark-users] Help With EPS/ISAKMP - Email found in subject

[Martin Visser <martinvisser99@xxxxxxxxx>]

Umm, ESP is natively protocol 50 that runs on top of IP (like TCP or
UDP do). AH is also part of the IPSEC suite and is IP protocol 51.

IPSEC can also be implemented by encapsulated ESP inside UDP. This is
often used for communicating on an adhoc basis through firewalls - it
is called NAT traversal or NAT-T.

Be aware that many firewalls are IPSEC aware and may need to have
IPSEC fixups (basically protocol hacks) to be enabled.

Regards, Martin

MartinVisser99@xxxxxxxxx



On Thu, Jun 18, 2009 at 7:41 AM, Robert D. Scott<robert@xxxxxxx> wrote:
> IP is !ESP.  Permit ESP as well.
>
> Robert D. Scott                 Robert@xxxxxxx
> Senior Network Engineer         352-273-0113 Phone
> CNS - Network Services          352-392-2061 CNS Phone Tree
> University of Florida           352-392-9440 FAX
> Florida Lambda Rail             352-294-3571 FLR NOC
> Gainesville, FL  32611          321-663-0421 Cell
>
>
> -----Original Message-----
> From: wireshark-users-bounces@xxxxxxxxxxxxx
> [mailto:wireshark-users-bounces@xxxxxxxxxxxxx] On Behalf Of Josue Del Valle
> Sent: Wednesday, June 17, 2009 4:41 PM
> To: Community support list for Wireshark
> Subject: Re: [Wireshark-users] Help With EPS/ISAKMP - Email found in subject
>
> Hi,
>
> Thanks for replying.
>
> I was just shown the ICLs and for troubleshooting purposes, IP, UPD and
> TCP have been allowed from ANY interface in the DMZ to ANY interface on
> the trusted network.  Is there anything else that could be causing this?
>
>
> -----Original Message-----
> From: Robert D. Scott [mailto:robert@xxxxxxx]
> Sent: 2009-06-17 4:20 PM
> To: 'Community support list for Wireshark'
> Subject: [SPAM] - Re: [Wireshark-users] Help With EPS/ISAKMP - Email
> found in subject
>
> Sound like an ACL or firewall between the DMZ and the other network
> dropping
> ESP.
>
> Robert D. Scott                 Robert@xxxxxxx
> Senior Network Engineer         352-273-0113 Phone
> CNS - Network Services          352-392-2061 CNS Phone Tree
> University of Florida           352-392-9440 FAX
> Florida Lambda Rail             352-294-3571 FLR NOC
> Gainesville, FL  32611          321-663-0421 Cell
>
>
> -----Original Message-----
> From: wireshark-users-bounces@xxxxxxxxxxxxx
> [mailto:wireshark-users-bounces@xxxxxxxxxxxxx] On Behalf Of Josue Del
> Valle
> Sent: Wednesday, June 17, 2009 4:16 PM
> To: wireshark-users@xxxxxxxxxxxxx
> Subject: [Wireshark-users] Help With EPS/ISAKMP
>
> Hi,
>
>
>
> I was hoping someone could help me with this issue.   I have configured
> IPSec on two Windows 2003 servers using certificates as the
> authentication.
> If I run wireshark from one of the server while having both servers on
> the
> same network, I can see a bunch of ESP which indicate to me that the
> traffic
> is encrypted between the two servers.  If I move one of the servers to
> another network (DMZ) and try to communicate with the server located on
> the
> trusted network, I can't and instead of getting ESP packets all I see is
> ISAKMP packets.  I have not change anything on the IPsec except the ip
> for
> the server that has been moved to the DMZ.  The trusted network as a
> 192.168.10.X subnet and the one on the DMZ is 192.168.20.X.
>
>
>
> If I remove IPSec I can communicate from the DMZ to the LAN as intended
> which indicate routing on the firewall is working fine.  I know it is
> kind
> of confusing, but I'm trying to figure out why WireShark shows ESP
> packets
> when the server is on the LAN and ISAKMP packets when the server is
> moved to
> the DMZ.
>
>
>
> Thanks,
>
>
>
> Josue
>
> Please remember coverage cannot be bound, amended or cancelled via the
> email
> or voicemail system. You cannot bind, alter, or cancel coverage without
> speaking to an authorized representative of Braishfield Associates, Inc.
> Coverage cannot be assumed to be bound without confirmation from an
> authorized representative of Braishfield Associates, Inc.
>
>
> DISCLAIMER:
> CONFIDENTIALITY NOTICE: Braishfield Associates, Inc. would like you to
> know
> that the information contained in this communication, including
> attachments
> is privileged and confidential. It is intended only for the exclusive
> use of
> the addressee. If the reader of this message is not the intended
> recipient,
> or the employee or agent responsible for delivering it to the intended
> recipient, you are hereby notified that any dissemination, distribution
> or
> copying of this communication is strictly prohibited. Insurance coverage
> can
> not be bound, amended or changed via an e-mail message without knowledge
> or
> consent from the insuring carrier. If you have received this
> communication
> in error please notify us by telephone immediately at (407) 825-9911 or
> e-mail disclaimer@xxxxxxxxxxxxxxx. Thank you.
>
>
>
> ________________________________________________________________________
> ___
> Sent via:    Wireshark-users mailing list
> <wireshark-users@xxxxxxxxxxxxx>
> Archives:    http://www.wireshark.org/lists/wireshark-users
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
>
> mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe
> ___________________________________________________________________________
> Sent via:    Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
> Archives:    http://www.wireshark.org/lists/wireshark-users
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
>
> mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe
>
>
> ___________________________________________________________________________
> Sent via:    Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
> Archives:    http://www.wireshark.org/lists/wireshark-users
> Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
>             mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe
>