Hi Faraz,
You set up a wrong filter. As a rule of thumb before try to capture X you should learn the behavior of that X from documentation/RFC/etc…
On Thu, Jan 29, 2009 at 5:54 PM, Syed Faraz Hasan
<Faraz_Hasan-S@xxxxxxxxxxxxxxxxxx> wrote:
Hi everybody!
This is my first post to this group and my expectations are high.
I am sending an email from my PC to another one on the same LAN. Using wireshark I am trying to see what packets are exchanged when emails are sent. I am using a filter "host <ip address of other PC>". I see other packets sent or received by that IP address except for my email. My IP address is simply not available on the ENDPOINT table. 3 protocols are mentioned TCP, UDP and Ethernet but none contain any packet from my IP address.
Please help me out!
Faraz
mv652@xxxxxxxxxxxx wrote:
Hi,
Are there any restrictions to using wireshark in a x64-bit environment
(Windows 2003)?
The stable version 1.0.5 seems to install and start fine, but the
development realease installs but crashes when trying to start.
I realise that may be why it is is still 'Development'. Is there a separate
mailing list for development releases I should mail?
I build and run trunk (albeit a little older) on Vista 64 bit business and it runs fine for me. Are you attempting to run a specific nightly build?
--
Regards,
Graham Bloice
___________________________________________________________________________
Sent via: Wireshark-users mailing list <wireshark-users@xxxxxxxxxxxxx>
Archives: http://www.wireshark.org/lists/wireshark-users
Unsubscribe: https://wireshark.org/mailman/options/wireshark-users
mailto:wireshark-users-request@xxxxxxxxxxxxx?subject=unsubscribe
--
Boaz.
