[TNS>] Thanks for the reply, Steve. See inline.
[TNS>] -T
> I run a series of tests via a loopback interface on Fedora 7. Is
> there any way to start tshark and have it monitor activity on the
> loopback, even if traffic is not yet being passed?
You should be able to just start it as tshark -i lo0 and it will wait
for traffic.
[TNS>] Yeah, I thought so to, but even from the 'root' id, I get this:
> tshark -i lo0
Running as user "root" and group "root". This could be dangerous.
Capturing on lo0
tshark: The capture session could not be initiated (SIOCGIFHWADDR: No such device).
Please check to make sure you have sufficient permissions, and that you have the proper interface or pipe specified.
0 packets captured
tnsfc64:/home/tennis
> ifconfig
eth0 Link encap:Ethernet HWaddr 00:1A:A0:3B:BA:63
inet addr:10.1.3.207 Bcast:10.1.3.255 Mask:255.255.255.0
inet6 addr: fe80::21a:a0ff:fe3b:ba63/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:10292473 errors:0 dropped:0 overruns:0 frame:0
TX packets:11689855 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:3099078860 (2.8 GiB) TX bytes:4613934958 (4.2 GiB)
Interrupt:17
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:923403 errors:0 dropped:0 overruns:0 frame:0
TX packets:923403 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:1100303931 (1.0 GiB) TX bytes:1100303931 (1.0 GiB)
Steve
_______________________________________________
Wireshark-users mailing list
Wireshark-users@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-users
