Hi,
>How did you know what it does
>("Note that it looks for a version number of 2 in the first octet, and a
>known payload type in the second octet, rather than a dynamic payload
>type.")
By experience and reading the code of packet-rtp.c presumably ;-)
This is not the first time the question has been raised...
See also http://wiki.wireshark.org/RTP
Regards
Anders
-----Ursprungligt meddelande-----
Från: wireshark-users-bounces@xxxxxxxxxxxxx
[mailto:wireshark-users-bounces@xxxxxxxxxxxxx] För Trevor Tolk
Skickat: den 5 december 2007 20:10
Till: Community support list for Wireshark
Ämne: Re: [Wireshark-users] RTP over UDP not automatically detected
Though this response is very delayed, I wanted to say that turning on
the 'Try to decode RTP outside of conversation' option worked great.
Sometimes there are a couple of packets that it doesn't recognize the
payload, but for the most part it works well for me.
I tried researching what that options does, looking for documentation
for it, and couldn't find any anywhere. How did you know what it does
("Note that it looks for a version number of 2 in the first octet, and a
known payload type in the second octet, rather than a dynamic payload
type.")
-----Original Message-----
From: wireshark-users-bounces@xxxxxxxxxxxxx
[mailto:wireshark-users-bounces@xxxxxxxxxxxxx] On Behalf Of Trevor Tolk
Sent: 2007-11-29 13:59
To: Community support list for Wireshark
Subject: Re: [Wireshark-users] RTP over UDP not automatically detected
I have a Toshiba phone system and I must manually tell it to decode the
UDP as RTP. I haven't dried the 'Try to decode RTP outside of
conversation' option.
-----Original Message-----
From: wireshark-users-bounces@xxxxxxxxxxxxx
[mailto:wireshark-users-bounces@xxxxxxxxxxxxx] On Behalf Of Jaap Keuter
Sent: 2007-11-29 10:45
To: Community support list for Wireshark
Subject: Re: [Wireshark-users] RTP over UDP not automatically detected
Hi,
...or you toggle the RTP preference "Try to decode RTP outside of
conversation" to true.
Thanx,
Jaap
maurizio simoni wrote:
> Hi,
>
> RTP is not automatically detected over UDP.
> RTP is recognized only if SDP info is present in signaling messages
> (for example SIP or SAP).
> If SDP is not present (this is the case of IPTV streams) the only way
> to decode RTP is to manually set the UDP payload as RTP.
>
> Same problem for RTCP.
>
> Mau.
>
_______________________________________________
Wireshark-users mailing list
Wireshark-users@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-users
_______________________________________________
Wireshark-users mailing list
Wireshark-users@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-users
_______________________________________________
Wireshark-users mailing list
Wireshark-users@xxxxxxxxxxxxx
http://www.wireshark.org/mailman/listinfo/wireshark-users
