Hello,
When I am
doing live capture with Wireshark using the “Capture filter” option
(host 172.16.59.240), my expectation is that I can able to see both the to and
from (source & dest) traffic with that ip address. But I can see only
incoming traffic (i.e. destination ip address only), it is not showing any
outgoing traffic from that ip address.
If I remove
that filter and start capturing, then I can see both incoming and outgoing traffic
with that ip address.
I am
doubting some setup problem in my Wireshark, but not sure where to change.
Can you
please help me on this issue.
Best regards,
Upendra
Please do not print this email unless it is absolutely necessary.
The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.
www.wipro.com
| 