Hi ,
I have done make clean. Then I configured, compiled and was able to
install successfully.I don't know what happenned the first time.
Thnx anyways
> -----Original Message-----
> From: wireshark-dev-bounces@xxxxxxxxxxxxx [mailto:wireshark-dev-
> bounces@xxxxxxxxxxxxx] On Behalf Of Stephen Fisher
> Sent: Tuesday, December 11, 2007 11:42 AM
> To: Developer support list for Wireshark
> Subject: Re: [Wireshark-dev] Installation error in wireshark-0.99.6
>
> On Tue, Dec 11, 2007 at 11:36:27AM +0530,
taraniteja.vishwanatha@xxxxxxxxx
> wrote:
>
> > I tried to install wireshark-0.99.6. I could could configure and
> > compile it successfully. When I tried to install it using "make
> > install", I got the following error:
>
> > /usr/bin/install: reading `.libs/libwireshark.so.0.0.1':
Input/output
> > error
>
> Are you running the make install as root or another user? Is it the
> same user that you used to compile Wireshark? Can you do an ls -l
> .libs/libwireshark.so.0.0.1 even?
>
>
> Steve
>
> _______________________________________________
> Wireshark-dev mailing list
> Wireshark-dev@xxxxxxxxxxxxx
> http://www.wireshark.org/mailman/listinfo/wireshark-dev
The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s) and may contain proprietary, confidential or privileged information. If you are not the intended recipient, you should not disseminate, distribute or copy this e-mail. Please notify the sender immediately and destroy all copies of this message and any attachments.
WARNING: Computer viruses can be transmitted via email. The recipient should check this email and any attachments for the presence of viruses. The company accepts no liability for any damage caused by any virus transmitted by this email.
www.wipro.com
