Open the "Capture" dialog and click the "Filter" button to create a
capture filter. Type in "Host <hostname>" for all traffic and "IP Host
<hostname>" for all IP traffic.
Ethereal uses the same packet capture syntax as WinDump. Check out the
WinDump docs here:
http://windump.polito.it/docs/manual.htm#Wdump
-jb
Sunday, June 2, 2002, 2:34:24 PM, you wrote:
JH> Greetings from the great State of Misery, err Missouri. :)
JH> Is there a way to setup a filter so that Ethereal only looks at ONE IP
JH> on the network?
JH> We ran into a problem this week with SOMETHING being sent to one of our
JH> HP Jetdirect boxes over and over again and we needed to find out the
JH> source IP.
JH> We used Ethereal (that gets installed with RH 7.3) and it worked fine -
JH> but just wanted to know if there was a way to only sniff one IP address
JH> that we happen to be having problems with so we don't have to wade thru
JH> the entire log.
JH> Thanks!
JH> Jim Hale
JH> ---
JH> Jim & Kathy's Website Collection
JH> http://hale.dyndns.org
JH> _______________________________________________
JH> Ethereal-users mailing list
JH> Ethereal-users@xxxxxxxxxxxx
JH> http://www.ethereal.com/mailman/listinfo/ethereal-users
