Ethereal-dev: Re: [Ethereal-dev] Adding Routing Label info to main window

Note: This archive is from the project's previous web site, ethereal.com. This list is no longer active.

Date Index Thread Index Other Months All Mailing Lists
Date Prev Date Next Thread Prev Thread Next
From: Ulf Lamping <ulf.lamping@xxxxxx>
Date: Sat, 21 May 2005 00:53:52 +0200
LEGO wrote:

>I thought aobut changing that too, but decided not to do it.
>
> Here's what I do to have the PCs in the columns:
>I went to preferences and changed the source and destination columns
>to be net_src and net_dst, now I see DPC and OPC when there are MTP3
>packets inside an sctp chunk.
>
>Beware that with SCTP the same IP packet can have more mtp3 messages
>in different chunks with different PCs, in those cases you'll see the
>PCs of the last message.
>
>I been wondering for a while whether it was or not the case to
>overwrite the transport (src and dst) address. I've decided it is not:
>I have packets from to the same pair of PCs going through several sctp
>associations, so I think is better to have also the IP addresses in
>the packet info.
>
>Luis
>
>On 5/21/05, Javier Acuña <javier.acuna@xxxxxxxxxx> wrote:
>  
>
>>Hi
>>
>>Could it be possible to add the Originating Point Code and Destination Point Code information of each packet to the "Source" and "Destination" columns of the main window??
>>
>>I don't mind implementing it myself, it's just that I don't know where to start.
>>
>>Best Regards
>>Javier Acuña
>>
>>    
>>
BTW: What *is* an Originating Point Code and a Destination Point Code?!?

Regards, ULFL