Wireshark · Wireshark-dev: Re: [Wireshark-dev] Adding pcap-ng pipe support to dumpcap

[Roland Knall <rknall@xxxxxxxxx>]

Sorry, that was meant to be gerrit. See https://code.wireshark.org/review/

cheers

On Wed, Nov 22, 2017 at 7:19 PM, Roland Knall <rknall@xxxxxxxxx> wrote:

Hi

Could you send this to gerri for review? It makes it a lot easier to integrate into master

cheers

Roland

On Wed, Nov 22, 2017 at 7:13 PM, James Ko <jim.list@xxxxxxxxxxx> wrote:

Attached is my patch to get this working (with caveats).

To support this involved reading the the pcapng block header and parsing the just the section header block for endianess.  Then just rewrites the all blocks using the original/input endianess format to the pipe without looking much further at the block contents.

It only supports one interface.  I don't fully understand how multiple interfaces are handled  but would probably require parsing the interface description blocks as well to get the linktype and snaplen to put in the interface table.

I also did not implement the use_threads option for packet processing.

There is #ifdef WIN32 bits but I don't know if any of that is correct as I didn't really touch it and did not even try to compile it.

I hope this gets this feature moving along.

Regards,

James

___________________________________________________________________________
Sent via:    Wireshark-dev mailing list <wireshark-dev@xxxxxxxxxxxxx>
Archives:    https://www.wireshark.org/lists/wireshark-dev
Unsubscribe: https://www.wireshark.org/mailman/options/wireshark-dev
             mailto:wireshark-dev-request@wireshark.org?subject=unsubscribe