Committed revision 22191.
Thanks
Anders
-----Ursprungligt meddelande-----
Från: wireshark-dev-bounces@xxxxxxxxxxxxx
[mailto:wireshark-dev-bounces@xxxxxxxxxxxxx] För Flavio Leitner
Skickat: den 20 juni 2007 20:30
Till: Al Chu
Kopia: wireshark-dev@xxxxxxxxxxxxx; Kent Baxley
Ämne: Re: [Wireshark-dev] [PATCH] Fix IPMI Completion Codes
On Wed, Jun 20, 2007 at 10:57:42AM -0700, Al Chu wrote:
> +static const ipmi_complcmd_dissect ipmi_complcmd_array[] = {
>
> You seem to cover a lot more completion codes than anyone would have
> expected. That's great! Thanks.
I deleted the ones which doesn't have a specific completion code and
the missing (I couldn't find them) are commented for future assign.
> + { 0x00, 0x08, 0x80, "Parameter not supported" },
> + { 0x00, 0x08, 0x81, "Attempt to set in progress value" },
> + { 0x00, 0x08, 0x82, "Attempt to write read-only value" },
> + { 0x00, 0x09, 0x80, "Parameter not supported" },
> <snip>
> + guint8 netfnr = netfn & 0xFE;
>
> It seems you are masking out the least significant bit of the network
> function because that bit accounts for request vs. response network
> functions?? Then using that subsequent value for comparisons against
> the 'ipmi_complcmd_dissect' table?
>
> I believe that completion codes are only going to be sent with response
> messages, so I don't believe there is any need to do this. Perhaps you
> could just use response network functions in the 'ipmi_complcmd_dissect'
> table and forget about masking out the least significant bit?
Right, what about the attached one?
thanks again,
--
Flávio
